| CONCRETE MIX DESIGN
Our certified team can provide your concrete mix design submittals in accordance with the ACI 211 requirements. We specialize in normal and lightweight concrete mix designs. Ship us your materials for the full range of materials testing, mix proportioning and performance evaluation. Our testing results were recognized and approved by the Department of Engineering, AIT, Thailand.
|
Below is an example of a typical show the densities and strength. In this report concrete mixes were established in accordance with ASTM C 796-97. Compressive strength tests were performed at 28 days and a table is show guideline of relationship between the dry densities of concrete and material content.
| 
|
|
|
|
KIS INNOVATE CO., LTD.
Since 2015
Copyright © 2019
by
TEAMKIS
This program is intended for mix design of foamed concrete or cellular concrete, may not be suitable for the end users intended application. The data is accepted in the mix design entry only. To determine proportions for a mix design follow these steps:
- Enter the cement content from the left table.
- Choose the water-to-binder ratio required to achieve.
- Enter the pozzolan content if used.
- Enter the dry density of concrete as desire.
- Enter the specific gravities of materials to be used in the right column.
- Enter the density of expanded foam.
Factors used by this calculator are as follows:
- Cement content for 1 sack has mass is 50 kg, equivalent to 0.036 m³ loose volume.
- Density of water at temperature of 4 °C is 1,000 kg/m³
|
|
KIS FOAM CONCRETE
www.kisinnovate.com
email address: teamkisinnovate@gmail.com
|
